Sprockets
Sprocket Information
There are a huge number of sprockets manufactured and so therefore we cannot list them all here.
We can supply you (in most cases) with sprockets to increase your acceleration, e.g. less teeth on the gearbox sprocket, or to give you faster top end, e.g. less teeth on the rear sprocket. These are all individual tastes and we can discuss them either in person or on the telephone.
We keep a wide variety of sprockets in stock. The most popular are steel as they are harder wearing and less expensive than the aluminium ones. Should we for some reason not have your particular sprocket in stock, it can normally be obtained and delivered to you within a very few days.
For availability, prices and advice please contact us; we will always endeavour to give you the best prices we can.
Special Sprockets
Front Sprockets by APE
Offset front sprockets are available although only in a limited variety of sizes and fitments. Prices and delivery vary. Please phone for details and remember to have all the relevant details to hand when you call (see below).
For offset front sprockets you will need to provide us with the following information (in mm):
- Length of offset (A)
- Size/pitch of chain
- Number of teeth
- Engine and model
Rear Sprockets
Specially machined sprockets can be made to your dimensions. Alloy blanks are available with teeth cut to allow fitting to any machine, ideal for obsolete models! Delivery is normally approximately 7-10 working days.
For rear sprockets you will need to provide us with the following information (in mm):
- Counter bore diameter (A)
- Size/pitch of chain
- Number of teeth
- Rear wheel/model
- PCD of fixings (B)
- Number of bolt holes and diameter of bolt holes